Orbital Assault Capsule Alternate Turret for Imperialist Legions - Supported- 8mm

These parts are not meant to replace or be compatible with any other previously available kits.

Look for other parts for this kit on my page.

Any remains of supports will need to be thoroughly removed from areas where the door meets the base top as the door closes, or it will not close properly.

Would recommend a very small amount of poster putty in the holes for the door pegs to prevent them from being too loose or floppy and to help stay closed.

Would very strongly recommend dry-fitting all parts before gluing, and testing proper articulation as well as only using glue between the base top and bottom on the inner ring of the base bottom (with the 5 pegs), and away from the door pegs, unless you want the doors glued open or shut.

For proper fit between parts, would recommend orienting the pieces in the slicer so that the contact surfaces are parallel to the plate or exactly 90 deg to it (upright). This is particularly important for the top of the the Base Bottom, and the bottom of the Base Top.

Scaled for 8mm Resize to 80% for 6mm or just rock it.

Recommend getting the turret inside the stabilizers, inverting the stabilizers piece, and holding the turret in position ready to be put in place with tweezers before adding glue. this bit can be a bit fidgety and you don't want to get glue all over the place.